Download the installation manual, Cadillac CTS-V rear suspension Snubber

Cadillac manuals for Download installation manual Snubber Cadillac CTS-V rear suspension .
Rear suspension Snubber installation instructions:
Step 1. -Lift and support with a note: If you are using the lift trucks, parts may be omitted. ).To raise the front of the car, (depending on the slot by using), you may need to initially raise the car's side (using secondary Jack) to obtain clearance for hydraulic jack on the front of the car.After you do this, the support of the car with Jack stands located in cages, Cross country, as shown in Figure1. (b)).On the front of the car serviced now raise the back of the car.This is done with Jack, side frequently on the car.The jacking point will be the rear axle or differential housing.The rear of the car is int he air, please support it with the other stands of Jack two sub-frames of the car.You may want to place the wood between the stand lock ab Jack and subpages of the frame to avoid any scatches. Step 2. Removal of the rear axle of car cradle supported, you can now Delete nitka int about four (4) screws that secure the cradle of the rear axle. ). place the hydraulic jack in difference and apply pressure, only enough to support a cradle. (b)).Locate the four screw cradle (4) (includes Figures4, 5 and 6).There are two screws in the front and two rear bolts int he after each page. (c)).Using Socket 24mmdeepwell, remove the bolts front cradle. (d)).Remove the rear screws, now using 2 1mmdeepwellsock et with6 "extension. (e)).Now you can lower the axle, and the cradle of the Congregation. allow the Assembly to lower until stop, located in the "free hang".For additional safety leave Jack enclosure difference and apply light load to support the Assembly.
Download