Jaguar XKE 6 cylinder Hardtop Setup Guide

Jaguar manuals for installation manual cylinder Hardtop Jaguar XKE 6.
Hardtop installation instructions:
A. prior to the introduction of a Hardtop car to: 1. make a convertible top to normal top down position, making sure to Snap a tie with two rear leather down the cords. Alternately you may remove the top cloth of the car. 2. Clean the upper part of the windshield frame and rear deck area. 3. Lubricate the bottom rubber deck Hardtop with silicone grease or petroleum jelly. (Keep the grease from the surface of the painting) 4. Lubricate the rubber side 5 Hardtop. Attach.To the plate (with straps to hold the rear) metal convertible frame adaptor for the articulation of the frame (for top bolts) – one on the page. The plate shall be vertical with the end rounded up. 6. on the front fitting unscrew a Hardtop.
(B) place a Hardtop car: 1. make sure that there is a danger that does not get side moldings zacisniecia between the top and windshield frame. Align top windshield frame and install three hooks "J". Hand tighten the fasteners, be careful not to over tighten (especially. The Centre, one) 2. Hooking the rear hold assemblies for tiles and hand-tighten the Adapter Assembly. 3. a Casted windows and closing the door to ensure that the space between windows and rubber molding is the same on both sides. 4. during Coke pushing on the front of the Hardtop, tighten both sets of fastener front. 5. where the advance is the correct position and black knobs are tight, Trim excess rubber from the window (front and rear) scissors or knife.

Download