Rear exhaust System Setup Guide corvette for 2005-2008

Corvette rear exhaust System installation/removal Manual.
Remove the exhaust system:
1. Loosen the clamps shown in Figure 1 is located just below the transmission at the rear of the vehicle. 2. using the socket 13 mm, unbolt the spring hangers, located at the front of the clamps. Place the screw for use during the installation of the new system, the exhaust system. 3. with a stand of the silencer or additional person have Assembly pipe h to position using Socket 15 mm flanges located just unbolt for catalytic converters. Place the seals on the equipment and on the side for use during the installation of the new system, the exhaust system. 4. Remove the Assembly pipe h with the vehicle by dropping the front than the rear sliding out at the factory by wiring harness/muffler axle. 5. using the spray type grease, lubricate hooks at the rear of the vehicle just above the tip assemblies. 6. Beginning with the driver's side of the vehicle, remove the hooks of insulators and the removal of rubber mounting of the silencer from the vehicle. 7. in the case of vehicles equipped with automatic transmissions, you must remove the heat shield on the side of the passenger from the fuel tank. Using a set of pliers or similar, the bend tab of the down. 8. Repeat step 6 to remove the mounting of the silencer on the side of the passenger. Download