2004-2008 Chrysler 300 C exhaust system installation/removal Manual

Chrysler 300 C exhaust system installation/removal Manual.
Exhaust system installation/removal instructions:
Note removing the exhaust system: with a used vehicle, we suggest penetrating lubricant spray liberally applied to all exhaust fasteners, and allowing for a significant period of time for the chemical to lubricate the threads before attempting to disassemble. 1. Unbolt the clamps shown in Figure 1 is located just behind catalytic converters. 2. remove the support bar Unbolt and Centre is located just behind the pipe y. 3. Remove the tape media, located on the rear-mounting of the silencer. 4. Lubricate all hangers and rubber insulators. 5. using a tripod of the silencer or additional persons up to the exhaust system in place, remove the hooks of insulators rubber and removal of exhaust from the vehicle.
The exhaust system installation: 1. position the Clamp on the ends of the enlarged Assembly pipe y and set it to the position. Do not tighten the clamps. 2. using the original hardware, also install support for the Centre. 3. place the screw end enlarged front mounting of the silencer and set it to the position. Do not tighten the clamp. 4. enlarged end clamp for mounting the rear silencer and set it to a position, making sure to install the hooks for rubber insulators. 5. Clip strip of land on hanger services forward of the rear silencer. 6. check exhaust system for proper ground clearance, and to adjust the tip. 7. having determined the correct position to tighten the clamps Accuseal 32 to 35 ft. lbs. front flange to Tighten the vehicle manufacturer's recommendations. 6. before you start your car, make sure you check all cables, hoses, brake lines, body parts and tyres in the safe clearance of the exhaust system. 7. start the vehicle and check for any leaks. If the leak was found, determine the cause (eg. Clamp loose or incorrectly positioned) and repair if necessary.

Download