C4 Corvette roof installation guide

Corvette manuals for Manual installation of the roof C4 Corvette .
Roof installation instructions:
Design 84-early 86 roof installation-1. Make sure that the front cone/plate Assembly is loose enough to move manually. 2. set the roof of the car and tighten the screws of the rear of the Centre. If the bolts are difficult to start, please check again to make sure that the roof is centered and have a second person push toward the rear of the car roof to compress new weatherstrip. 3. Tighten the outer two rear Locator bolts on each side. Now is the rear part of the roof. 4. tighten the mounting bolts in front. You may need to move for mounting the plate while trying to line up and tighten the mounting bolts in front of the other part. 5. tighten the cones with fine 1 1/8 "installation wrench. 6. loosen the Centre of the front Mounting bolts. Retighten the front propeller watch when the roof of the front lens makes even contact with windshield weatherstrip. Front edge should place only about 1/8 "pressure weatherstrip for proper sealing, as the front bolts are tightened. Too much pressure may cause the warps, cracks or other problems. Too little pressure could result in air or water leaks. If you feel that there is too much pressure to the front of the lens see 2nd design installation instructions below to adjust the front roof mounting brackets. Download