Volvo Penta workshop manual MD11C D MD17C Methods of work described in the manual for the service shall apply to the work carried out in the workshop. The engine was removed from the boat and is installed in the engine support. Tightening torque-protractor (corner). Not nuts for locking of reuse, which were removed during dismantling, since they have reduced service at reused-nuts when mounting used new or re-installation.
Component management: stop device, screw the air injection pump, pipe supply nuts, locking-screw, the crankshaft Centre bearing. . Pressure equalizing valve oil pressure sender. PISTONS AND CONNECTING RODS. The removal of verification of the crankcase covers (6 mm socket head). MD17: remove sump and strainer. Remove the carrier of the crankshaft.
Monday, July 4, 2011
Volvo Penta workshop manual MD11C D MD17C
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.