C6 Guide Lt./2LT Hud installations Corvette.
Hud installation instructions:
Step 1: the radio console Surround Center and disposal: first you have to do this, remove the lid Center console. Odprawiana is in the four bolts T15 torx. You can remove a small plastic cover of the rear hold the nuts. The following illustration shows the console lid and nuts already deleted. Turning attention to the front of the console, eyes shift will need to be removed. Twist Tester plastic ring on the upper boot leather clock you e 35 degrees or so, and then Pull Up on the shift knob. You will need to use some of the forces here, but don't worry, not broke. It should be noted that I had to brake the car in neutral, but not e downloaded, I believe that it is necessary. To remove the emergency handle, pull down the skin and remove boot head screws Phillips. Pull-up handle shift to delete it. This took much more effort than I think that in this way. Then, remove the two screws on the right side of the console. Remove these screws 7 mm. towards the centre console there is another bolt to remove. To access, delete, select the cover by pulling the Ride up. I managed to do this manually, but you can use a screwdriver or a knife to help.
Home » Corvette » Manual installation of Lt./2LT Hud with Corvette C6 2005-up
Thursday, February 24, 2011
Manual installation of Lt./2LT Hud with Corvette C6 2005-up
Related to: Corvette
This Manual installation of Lt./2LT Hud with Corvette C6 2005-up article was writen by :service Manual on date 2:45 AM
tagging as :
Corvette
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment
Note: Only a member of this blog may post a comment.