Manual installation of starter engine remote control 2010 Honda Accord A/T 2-door

Honda Manuals for installation manual remote control engine Starter 2-door 2010 Honda Accord A/T .
Remote control of engine Starter installation instructions:
Note: this antenna should install only if the ambient air temperature of 15 ° C (60 ° F) or above. 1. make sure that you have the anti-theft radio code, then save the preset radio stations. 2. Disconnect the negative cable from the battery. Setting control 3. Using a small screwdriver flat tip fit switches in the control unit (Accessories) to the location shown. By using isopropyl alcohol on a towel shop, clean the area where the protective tape will attach control. Remove adhesive backing and include protective steering. Note: • choose switches occurred before the unit is plugged in. • If that switch settings is not correct, that the engine starting the remote will not work correctly. • If adjusting switches from the control unit, vehicle mounted, touch the metal part of the screwdriver to any metal parts of the vehicle to perform any static electricity. • If you change the settings for the switch from the unit connected, disconnect the unit again connect it before changing the settings. 4. remove the driver's dashboard lower cover (eight clips, two hooks and disconnect the vehicle). 5. the V6 model only: Remove the driver's dashboard screens (three clips and one pin).
Download