Download Corvette 1982 Parts Manual

Corvette 1982

1997-2003 C5 Corvette doładowanego compressor system installation manual

C5 Corvette Compressor Installation manual doladowanego system.
Supercharger system doladowanego installation instructions:
1. Raise the vehicle on a hoist motor, using the factory recommended pick up points. You can find in the manual of manuals or shop owners for these locations. 2. remove the stock hood by disconnecting the electrical connector hood lamp, un-clipping, small gas charged shocks and remove hood screws four 13 mm socket wrench.

C3 Manual transmission Corvette T5

Corvette manuals for installation manual T5 transmission Corvette.
T5 transmission: installation instructions
Content: frame, clutch, the adapter plate, tunnel, move, transmission.
Frames: If you are installing to the C3, which already has a manual trans, you have welded the crossmember. If you do the swap as a team, the engine/trans, trans, you won't be able to install without cutting crossmember.

C4 Corvette roof installation guide

Corvette manuals for Manual installation of the roof C4 Corvette .
Roof installation instructions:
Design 84-early 86 roof installation-1. Make sure that the front cone/plate Assembly is loose enough to move manually. 2. set the roof of the car and tighten the screws of the rear of the Centre. If the bolts are difficult to start, please check again to make sure that the roof is centered and have a second person push toward the rear of the car roof to compress new weatherstrip. 3. Tighten the outer two rear Locator bolts on each side. Now is the rear part of the roof. 4. tighten the mounting bolts in front.

Manual installation of Lt./2LT Hud with Corvette C6 2005-up

C6 Guide Lt./2LT Hud installations Corvette.
Hud installation instructions:
Step 1: the radio console Surround Center and disposal: first you have to do this, remove the lid Center console. Odprawiana is in the four bolts T15 torx. You can remove a small plastic cover of the rear hold the nuts. The following illustration shows the console lid and nuts already deleted. Turning attention to the front of the console, eyes shift will need to be removed.

Rear exhaust System Setup Guide corvette for 2005-2008

Corvette rear exhaust System installation/removal Manual.
Remove the exhaust system:
1. Loosen the clamps shown in Figure 1 is located just below the transmission at the rear of the vehicle. 2. using the socket 13 mm, unbolt the spring hangers, located at the front of the clamps. Place the screw for use during the installation of the new system, the exhaust system. 3. with a stand of the silencer or additional person have Assembly pipe h to position using Socket 15 mm flanges located just unbolt for catalytic converters. Place the seals on the equipment and on the side for