Thursday, January 19, 2012

2001 Lincoln LS Workshop Manual

2001 Lincoln LS

This 2001 Lincoln LS Workshop Manual available in 10 pages and will describes about Intake Manifold Removal in 27 steps. Check out the content snippet below : 1. Disconnect the battery ground cable. 2. Remove the air cleaner outlet tube. 3. CAUTION: The coolant drain procedure must be followed exactly or damage to the engine may occur. Drain the engine cooling system. 4. Remove the cowl vent screen. 5. Remove the engine compartment brace. 6. Disconnect the accelerator and speed control cables. 7. Disconnect the vacuum hoses. 8. Disconnect the vacuum line. 9. Disconnect the EGR valve to exhaust manifold tube. 10. Remove the EGR valve. 1. Remove the two bolts. 2. Remove the valve and discard the gasket. 11. Disconnect the camshaft position (CMP) sensor electrical connector and separate the connector from the fuel injection supply manifold. 12. CAUTION: To remove normal fittings, squeeze the tabs and pull straight out or damage to the fitting may occur. Disconnect the evaporative emission canister purge valve line.get

This 2001 Lincoln LS Workshop Manual article was writen by :service Manual on date 8:50 PM
tagging as :

0 comments:

Post a Comment

Note: Only a member of this blog may post a comment.